Check FCoE Parameter On ESXi and Switch F10 S5000

Reading Time: 2 minutes Hi all, according to my last experience with FCoE, I’d like to share a step by step guide on how to check everything before configuring FCoE on ESXi and how to find if it works correctly. First of all you need to note down your FCoE adapter model and check firmware and driver version supported…

Configure VLT on Force10 S4810

Configure VLT on Force10 S4810

Reading Time: < 1 minute Configuring VLT is easy. You need just to run the following commands. Configure a Static LAG between the VLT swithes configure interface range fortyGigE 0/56 , fortyGigE 0/60 no shutdown interface port-channel 128 channel-member fortyGigE 0/56, 60 no shutdown Configure a VLT Domain on each VLT Peer On first switch configure vlt domain 1 primary-priority 10 back-up…

Compellent Best Practises with VMware vSphere 6.x

Compellent Best Practises with VMware vSphere 6.x

Reading Time: 2 minutes In this post I just want to summarize the best practises need for configuring correctly vSphere 6.x with DELL Compellent.. The original article is located here:   FC HBAs For each of these adapters, the method to set the driver queue depth and timeouts uses the following general steps: 1. Locate the appropriate driver name for…

Show FC module on ESXi and load it

Show FC module on ESXi and load it

Reading Time: < 1 minute Some times we need to find, what are the driver modules loaded in the VMkernel, for example the ethernet and fiber channel HBA adapters driver modules. Some times we need to find the driver version, features and capabilities of the driver and its associated device. And many times we need set or change some advance…

DHCP High Availability with Windows Server 2012 R2

DHCP High Availability with Windows Server 2012 R2

Reading Time: 4 minutes Hi all, in this guide I will show you how to configure the DHCP service in high availability mode. In previous Windows versions like Windows Server 2008 R2 and Windows Server 2003, you have two options to make DHCP highly available: DHCP in a Windows failover cluster. This option places the DHCP server in a cluster…

Brocade enabling and disabling Access Gateway mode

Brocade enabling and disabling Access Gateway mode

Reading Time: 2 minutes Use the following steps to enable and disable Access Gateway mode. After you enable AG mode, some fabric information is erased, such as the zone and security databases. Enabling AG mode is disruptive because the switch is disabled and rebooted. For more information on the ag commands used in these steps, refer to the Fabric…

Check Out koodzo.com!